The higher temperature is the main source of difficulty: it can be harder to heat up a joint to the right temperature without overheating the iron tip or the components. So it's mainly a case of getting good thermal contact between the iron and the joint, and having a powerful enough iron and the right size tip.
(One trick that can be very helpful is pre-heating: e.g. placing a board on a hot-plate at ~150C or so, or using a hot air gun to do the same. This means the iron doesn't need to heat a much. But of course this makes placing and holding the components more difficult)
(One trick that can be very helpful is pre-heating: e.g. placing a board on a hot-plate at ~150C or so, or using a hot air gun to do the same. This means the iron doesn't need to heat a much. But of course this makes placing and holding the components more difficult)